There is a problem in the design view of this patch. it shows a smaller area appearing as the design area, but in fact it’s much smaller than it should be, and the area outside the green line is darkened. anyway it’s wrong. :), the design shows very small compared to the actual patch.
It was ok when I designed a different shape patch(oblong)
I have taken a look at the design tool view of the square patches and I don’t think there is an issue from what I can see. If you have a screenshot, please feel free to share here and we can check it out.
Thanks Mark for your time. in the screenshot I have had to make this image a lot bigger “outside the margins” for it to fill up the space nicely. Normally to go outside this margin would take it outside the product edge.
I had no issues with the previous shape, it behaved normally, here it did not.
