suggestion: Improve making mugs/cups product creation

[onshidesigns]

I want an image on the left side or right side of a mug.  There are dotted lines and that's good to marks where to centrer image.  Problem is dotted lines need to extend vertically top to bottom.  As it is now, the dotted lines are not as helpful as needed.  Also can I clip the image to dotted lines?

This is a small change that will same me a minute of time.   

[Pádraig]

Hi @onshidesigns,

Thanks for your feedback here. I see what you are referring to in the design to so I'll pass this on to our team to take a look at.

Pádraig

[alissag]

A tip on this is that Zazzle might try to make the design tool for mugs similar to that for paper cups or similar products, where you can choose to use the layer panel that shows the entire print area or use different layer panels for front and back of the mug.