I can not seem to find anything on this. I am wondering if there is anyway to adjust an image after using the mirror in tile option allowing you to put the image where you want it? As far as I can see is there are only four choices when you rotate the item. If you want to move it when tiled white space shows up between the tiles. I tied to lock the image but that does not allow you to do anything. If you spend hours on resizing the image there is a chance you will get it where you want it. Not sure anyone will understand what I mean. Thanks
That part doesn't show up (fit) on my screen and I totally forgot about it. I had tried it before but could not figure it out. I didn't use it enough to really test it. I will have to reduce my browser size so it shows up and mess around with it. Thank you very much. You know that old saying 'Out of site, out of mind' - That and things in the back of the refrigerator get forgotten 🙂 I Use a 13" laptop you would think that the entire area of options would fit across it. Again thank you
Hi Kashmier you can also reduce the tile size by directly dragging and resizing from the image itself. General order is Align, Resize and then Tiling.Hope this helps.
I have had this same issue for a long time and have not as yet found a fix. When using the mirrored tile option the image moves and therefore you cannot center an image in the repeated pattern/move it to the top or bottom of the design area etc... I hope someone has figured this out and can explain - thanks!
Dont touch the pattern, just change the tile size until you are satisfied with the pattern composition. just change one of the fields, width or height, the system makes the other proportional
