Rugs - Several issues: placement tool, image handling + previews on vert. rugs
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-23-2023 06:30 AM
Noticed several technical issues on the new rugs:
- Design placement tool labeled and working incorrectly.
- Design area cut on top and bottom in vertical orientation.
- Images imported in vertical orientation are rotated by 90° and stretched. Issue only in designer, previews are correct (except detail view).
- Vertical designs on in-situ views are rotated the wrong way and are shown upside down (same issue as on other products like paperweights).
- Vertical designs on the detail view are shown in the incorrect, rotated, and stretched view as within the designer.
- The designer requests 100 dpi minimum resolution on imagery, which is significantly higher than these rugs are most certainly printed with (standard print dpi from 50 to 70). This leads to the upload of unnecessarily large files to avoid the warning (min. 14800 pixels on the largest 12x9' size). Can it be lowered to 50 or at least 70 dpi?
- Square images filled with the "Fill" tool on the largest 12x9 size are not well filled on the round size (approx halfway between print and bleed border). Can this be changed on the round size so these images get filled up to the whole bleed area?
Thanks!
──────────
FX GRAPHICA Art & Design | PET’S DREAMLANDS » Store - Facebook | CONTACT: fio@fxgraphica.com
FX GRAPHICA Art & Design | PET’S DREAMLANDS » Store - Facebook | CONTACT: fio@fxgraphica.com
0 REPLIES 0

