Binder image alignment off, wasn't when I created it
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-03-2022 09:47 AM
When I made these binders 2 years ago the alignment was displaying correctly on the front and the back, but now the preview is showing that the front is noticeably off. Should I leave it alone or remake them? I copy pasted from front to back and did not use a background image that stretched over the whole area
I vaguely remember a binder issue on the old forum, but have no idea what the solution was or if it was this problem.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-03-2022 12:36 PM - edited 02-03-2022 12:37 PM
It looks perfect to me. Are you perhaps looking at the front/inside view?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-03-2022 01:26 PM
Sorry, I wasn't very specific when I explained it. I'm looking at how the solid stripe runs around from the front to side to back. The stripe looks like it shifted down a bit and does not run in line with the back and side. Maybe it is because the way the binder is open in the image in my example? I think the product previews changed a while back so it looks different.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-03-2022 03:26 PM
ah, I see. That is probably trying to emulate the crease.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-03-2022 03:33 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-19-2022 10:23 AM

